APPLIED OPERATIONS/ Protocol processor
IV.
OPERATION INSTRUCTIONS
IV .
2-196
Page
It is possible to check which I/O board is being used by the following
method.
In case that I/O2 is used, [Pan][Zoom] group boxes on [Acquire] panel
cannot be selected because arrows are grayed out as shown below when
the board is started.
In case that I/O3 is used, it is possible to select [Pan][Zoom] group boxes
as arrows appear as shown below when the board is started.
TIP
It is grayed out.
Selection cannot
be done.
Selection possible
To Next Page
Loading...
