APPLIED OPERATIONS/Changing the Image Display Method
IV.
OPERATION INSTRUCTIONS
IV .
2-218
Page
4. Click the <New Page> button. A new [Display] panel appears showing the same
images as the displayed image. The number of the displayed images is as set in
step 2 above.
Use the <Retile> button when it is required to re-arrange the images in
the currently displayed [Display] panel.
5. Click the top left image of the displayed images.
Buttons appear above the clicked image.
6. Switch the image display using the displayed buttons.
For details on the display switching method, see sections 2-5-3, “Switching
the Displayed Channels”, 2-5-4, “Displaying Merged Image of Multiple
Channels” and 2-5-5, “Switching the Display Method of Multiple Images”.
7. Perform steps 5 and 6 above for each of the displayed images.
Fig. 2-79 Panel Showing 2-Channel Mode Images in Different Display Methods
Fig. 2-79 shows a panel where the display methods are varied as shown below.
Z(2)
Z(1)
NOTE
TIP
To Next Page
Loading...
