APPLIED OPERATIONS/Image Analysis
IV.
OPERATION INSTRUCTIONS
IV .
2-286
Page
hen the image is composed of multiple image slices, the range of
image slices to be subjected to the operation can be set using the
<Set start position> and <set end position> buttons above the images.
First display the image slice to start the operation using the <Display>
button and click the <Set start position> button. Then, set the image
slice to end the operation in the same way as above.
With an image acquired in XYZT observation, the slice images
(cross-section (Z)/time lapse (T)) to be subjected to the operation can
be selected using the <XYZ series> and <XYT series> buttons above
the image.
4. When the image was acquired in the multi-channel mode, select whether the
multiple channels are operated simultaneously or only one channel is operated.
To select the target channel(s), use the <Display channel switch> buttons. Only
the channel(s) being displayed will be analyzed.
Example) When only the Ch1 image is displayed, only the Ch1 image is
analyzed.
For the switching of channels, see section 2-5-3, “Switching the
Display Channels”.
<Set start position>
button
<Set end position>
button
<Successive display>
button
<XYZ series>
button
<XYT series>
button
<Display channel switch>
buttons
TIP
TIP
TIP
To Next Page
Loading...
