APPLIED OPERATIONS/Building an Image from a Different Viewpoint
IV.
OPERATION INSTRUCTIONS
IV .
2-295
Page
Among the multiple image slices composing the XYZ image, the range of image slices to be used
in extend image building can be specified.
1. Display the image slice to be set as the start image by using the <Display> buttons at the top
of the [Display] panel.
2. Click the <Set start position> button at the top of the [Display] panel.
3. Display the image slice to be set as the end image by using the <Display> buttons at the top
of the [Display] panel.
4. Click the <Set end position> button at the top of the [Display] panel.
The <Set start position> and <Set end position> buttons are valid in
the pushed-in condition. To cancel a previously set start or end
position, click the <Set start position> or <Set end position> button
again.
When it is required to analyze the built extended-focus image or save it
in the Fluoview Multi Tiff format, create the extended-focus image as a
separate image from the original image. See section 2-8-1-2, “Turning
Built Image into Single Image”.
<Set start position>
button
<Set end position>
button
NOTE
NOTE
To Next Page
Loading...
