APPLIED OPERATIONS/Building an Image from a Different Viewpoint
IV.
OPERATION INSTRUCTIONS
IV .
2-299
Page
1. Display the [Display] panel of the XYZ (multiple sections) image.
2. Click the <Make Multi Plane View> option button in the [Rendered View] panel.
The [3D-] panel is created to start the line image building.
Fig. 2-125 Panel showing the line images to be viewed in Z direction
If you change the slice to be displayed with the <Display> button, [Slice]
and [Z:] aren’t effected.
[Slice] and [Z:] show current slice and Z position according to moving the
red or brown line indicating XZ or YZ-direction on the XY-direction image
displayed left above.
<Make Multi Plane View>
button
Image display in XY-direction
The line image to be displayed
in XZ or YZ-direction can be
moved by dragging the red line
(XZ) or brown line (YZ) on the
XY-direction image.
Line image display in YZ-direction
Display the image of the line
specified on the XY-direction image.
Line image display in XZ-direction
Display the image of the line
specified on the XY-direction image.
Upper row: shows the current slice and the steps in Z-direction acquiring the image.
[z=]: the number of current steps
[Slice]:the number of current slice
Lower row: shows the current X and Y coordinates and Z position on the XY-
direction image.
[X:]: current X position
[Y:]: current Y position
[Z:]: current Z position
TIP
To Next Page
Loading...
