Olympus FLUOVIEW FV300 - Page 426

APPLIED OPERATIONS/Viewing Images Following the Progress of Time
IV. OPERATION INSTRUCTIONS
IV . 2-312
Page
4. Click the <Set start position> button. (If the start position is not set, image No. 0
becomes the start image automatically.)
5. Display the image slice to end the successive display by using the <Display>
button at the top of the [Display] panel.
6. Click the <Set end position> button. (If the end position is not set, image No. n-1,
assuming that the number of images is n, becomes the start image automatically.)
7. Click and hold the <Display> button. The images will be displayed successively
from the start position to the end position.
Click the <Display> button to stop the successive display.
xxx
<XYZ series> button
Displays one of multiple images by selecting
it according to the cross-section (Z).
<Set start position> button
When successive display or frame-by-frame display is
required, set the image with which the display should
start. (“0” is set when this button is not used.)
<Display> button
Press to start display of n-slices of image from the start position to the end position sequentially
(successive display) or one (frame-by-frame display) or to stop successive display.
Holding the button displays image slices in successive display and clicking it displays image
slices by advancing frame by frame.
<Display> button
Press to start display of n-slices of image from the end position to the start position sequentially
(successive display) or one (frame-by-frame display) or to stop successive display.
Holding the button displays image slices in successive display and clicking it displays image slices by
advancin
g
frame b
y
frame.
<Bound> button
Every time successive display or frame-by-frame display in a direction
ends at the start or end position, the display is restarted in the opposite
direction.
<Set end position> button
When successive display or frame-by-frame display is
required, set the image with which the display should
end. (Assuming that the number of images is n, “n-1” is
set when this button is not used.)
<Z/T series switch> button
<XYT series> button
Displays one of multiple images by selecting
it according to the time (T).
<Loop> button
Successive display or frame-by-frame display is
repeated in the same direction.
<Loop/Bound switch> buttons
<Display speed switch> buttons
Set the speed of successive display.
<Rabbit> button
Press for successive display of image slices without pause.
<Clock> button
Press for successive display of image slices at the time interval set in the [Time series] sub-panel.
<Turtle> button
Press for successive display of image slices at an interval of 0.8 sec.