Software Setup/Setting the System Configuration
V .
MAINTENANCE
V.
1-11
Page
9. Display the [Hardware] panel in the front position.
In this panel, select Enabled/Disabled to enable/disable the automatic black-level
adjustment, enter the values for delay timing for TD unit, and enter the maximum
duration for continuous bi-directional scanning when setting fast scan mode.
[Delay Timing for TD Unit] group box
This data should usually be left in the default values and
does not have to be changed.
[Delay shutter changes (sec)] text box
Enter the opening/closing wait time of the shutter in the TD
unit in seconds.
[Delay for bulb changes (sec)] text box
Enter the ON/OFF wait time of the lamp in the TD unit in
seconds.
[Timing for bidirectional scanning]
group box
Enter the maximum duration for
continuous bi-directional scanning (in
seconds) when setting fast scan mode.
[Hardware] icon
To Next Page
Loading...
