Olympus FLUOVIEW FV300 - Page 61

Getting Started FLUOVIEW/Outline of LSM Observation Procedures
IV. OPERATION INSTRUCTIONS
IV. 1-23
Page
• Turning the laser power ON
Ar laser, Multiline Ar laser (type 176B and type 300):
(1) Set the power switch to ON.
(2) Turn the key to the ON position.
(The laser fan will start.)
After the key is set to ON, it takes tens of seconds before the laser
oscillation starts.
Kr laser:
(1) Set the power switch to ON.
(2) Turn the key to the ON position. (The laser fan will start.)
After the key is set to ON, it takes tens of seconds before the laser
oscillation starts.
HeNe (Green/Red) laser:
(1) Turn the key to the “I” (ON) position.
Ar laser power supply
(type 176B)
Ar laser power supply
(type 300)
HeNe (Green/Red)
laser power supply
(1)
(1)
(2)
(2)
(1)