Olympus FLUOVIEW FV300 - Page 98

Getting Started FLUOVIEW/Online Help
IV. OPERATION INSTRUCTIONS
IV . 1-60
Page
2. From the panel page tabs shown on the bottom right of the [Acquire] panel, select
the [Settings] sub-panel.
Fig. 1-9 [Settings] Subpanel
3. Select the <Scope Control> button. The window as shown below will appear.
Fig. 1-10 [Microscope Configuration] Window
<Scope Control> button
Displays useful information for the system
setup.
[SU] group box
[BARRIER FILTERS CH2]
indicates the barrier filters for
Channel 2.
[BARRIER FILTERS CH1]
indicates the barrier filters for
Channel 1.
[DETECTION MODE]
indicates the setting of the
DETECTION MODE slider.
[Optical Path] box
This represents the light
path selector knob.
[Analyzer] box
Represents the
U-MDICT3
analyzer
[Turret Cube] box
Represents
the cube turret.
[Filters] box
This represents the
filters.