Connecting the camera and computer
25
Starting OLYMPUS Studio
4
Connect the cable to the USB or IEEE1394 (FireWire) interface on
the camera.
5 Turn on the camera by turning the power switch on the camera
to ON.
The computer recognizes the camera.
Example of connecting a USB cable Example of connecting an IEEE1394
(FireWire) cable
• Do not add or remove another USB or IEEE 1394 (FireWire) device to or from
the computer when the computer is connected to the camera. Doing so may
cause a malfunction on the camera or a problem with OLYMPUS Studio.
• You can set OLYMPUS Studio to automatically start when the camera is
connected to the computer and the camera is turned on.
“Automatically starting OLYMPUS Studio” P.30
• For instructions on how to connect the camera and computer or insert the
media to the computer, refer to the operation manual provided with your
camera.
• For information on setting the camera mode, refer to the operation manual
provided with your camera.
Note
Tips
To Next Page
Loading...
Need help?
General
