Disconnecting the camera from the computer
29
Starting OLYMPUS Studio
4 Remove the USB or IEEE1394 (FireWire) cable from the
computer.
5 Turn off the camera.
• Be sure to use the Remove Hardware function on the computer before turning
off the camera. If you do not use the Remove Hardware function before turning
off the camera, the image data may become lost.
• When using the Remove Hardware function, the warning message “Cannot
stop the camera” may appear. If this occurs, confirm that image data is not
being transferred from the camera and then remove the USB or IEEE1394
(FireWire) cable.
Note
To Next Page
Loading...