Transferring images
38
Browse Window
• During the image transfer, do not turn off the camera, open the card cover of
the camera, or disconnect the connection cable. Doing so may cause a
malfunction on the camera or a problem with OLYMPUS Studio.
• Do not add or remove a hardware device to or from the computer when the
computer is connected to the camera. Doing so may cause a malfunction on
the camera or a problem with OLYMPUS Studio.
• If an existing file in the transfer destination folder has the same name as one of
the files you want to transfer, the [Overwrite] dialog box appears. In the
[Overwrite] dialog box, you can select one of the following methods for
transferring images.
[Skip] : Skips this image and transfers the next image.
[Overwrite] : Transfers and overwrites the image.
[Add Serial Number] : Adds a serial number to the end of the file name and
transfers the image with a different name.
[Apply to All] : Applies the same image transfer method selected to all
files with the same name.
• If an Olympus USB or IEEE1394 (FireWire) storage class camera is connected
to the computer, both the camera and the media can be specified as transfer
sources.
Note
Tips
To Next Page
Loading...