OM SYSTEM OM-5 - Page 135

Use the front dial to select an option.
Still pictur
e (S-IS)
S-IS Off
(Still-I.S. Off)
Image stabilization disabled. Select this option when using a
tripod.
S-IS AUTO
(Auto I.S.)
Image stabilization applies to motion on all axes. If panning
motion is detected, the camera will automatically suspend
image stabilization on that axis.
S-IS1
(All Direction Shak
e I.S.)
Image stabilization applies to motion on all axes.
S-IS2
(Ver
tical Shake I.S.)
Image stabilization applies to vertical motion. Use when
panning the camera horizontally
.
S-IS3
(Horizontal Shak
e I.S.)
Image stabilization applies t
o horizontal motion. Use when
panning the camera v
ertically.
Movie (M-IS)
M-IS Off
(Movie-I.S. Off)
Image stabilization disabled.
M-IS
1
(All Direction Shak
e I.S.)
Electronic image stabilization combined with VCM-controlled
image sensor movement.
M-IS
2
(All Dir
ection Shak
e I.S.)
VCM-controlled image sensor movement only.
Image stabilization may be unable to compensate for excessive camera motion or very slow shutter
speeds. Use a tripod in these cases.
You may notice noise or vibration while image stabilization is in effect.
The setting selected with the lens image stabilization switch, if any, takes priority over that selected
with the camera.
You can choose whether image stabilization will be performed while the shutter button is pressed
halfway. gC Custom Menu h [Half Way Rls With IS] (P. 277)
You can prioritize lens image stabilization. gC Custom Menu h> [Lens I.S. Priority] (P. 277)
135
Reducing camera shake (Image Stabilizer)
3.
C
C
C
B
B