OM SYSTEM OM-5 - Page 171

Role Function
RAWX (RAW quality)
(K only)
Switch between RAW+ JPEG and JPEG [KX] settings. Press the
contr
ol to switch from RAW or JPEG to RAW+ JPEG or from RAW+
JPEG to JPEG. You can also choose an image quality setting by
holding the button and rotating a dial.
Test Picture (KTEST)
(Konly)
Take a test shot. You can view the effects of selected settings in an
actual photograph. If you keep the control pressed while pressing
the shutter button, you will be able to view the results but the
picture will not be saved to the memory card.
Custom Mode C–Custom
Mode C4 (C–
C4)
(Konly)
Recall settings for the selected custom mode. Press the control once
to r
ecall saved settings (P. 77), a second time to restore the settings
previously in effect. The control continues to perform this function
when a custom mode is selected with the mode dial.
Exposure F (exposur
e)
Adjust exposure settings. Hold the control and rotate the front or
rear dial. Alt
ernatively, you can press the button to activate settings
and then rotate the dials. The adjustments available vary with the
shooting mode:
[P]: Use the front or rear dial or HI buttons for exposure
compensation. Use the FG buttons for program shift.
[A]: Use the front or rear dial or HI buttons for exposure
compensation. Use the FG buttons for aperture.
[S]: Use the front or rear dial or HI buttons for exposure
compensation. Use the FG buttons for shutter speed.
[M]
1
: Use the rear dial or FG button for shutter speed. Use the
front dial or HI buttons for aperture.
[B]: Use rear dial or FG buttons to switch between bulb/time and
live composite photography. Use the front dial or HI buttons for
aperture.
For information on adjusting exposure settings when [AUTO]
is selected for [ISO] (P. 98, P. 117), see “Adjusting Exposure
Compensation” (P. 90).
Digital Tele-converter
(e)
Turn the digital teleconverter on or off (P
. 208
). Press once to zoom in
and again to zoom out.
Keystone Comp. (P)
(Konly)
Press the control to view keystone compensation settings (P. 230
).
After adjusting settings, press the control again to exit. To cancel
keystone compensation, press and hold the control.
171
Assigning functions to buttons (Button Function)
1