Omron SYSMAC FH Series

WWW.NNC.IR
Operation log input information list
871
8
Appendices
Vision System FH/FZ5 Series
User’s Manual (Z340)
Getting the Specified Image Logging Information.
GetImageLogInfo
Parameters
Return value
Returns the specified image logging information.
Getting an I/O Module Identifier Name
GetIoModuleIdent
Parameters
Return value
If the I/O module identifier name is acquired successfully (character string), returns 0.
Otherwise, returns value other than 0.
kind
Type of image logging information to acquire
• ImageLogMaxCount: Maximum number of images that can be logged in controller
memory
• ImageLogCount: Count of logging images held in the controller memory
ioModuleNo
I/O module number
0: Registers ParallelIo (Parallel I/O). (Fixed)
1: Registers any of the following I/O modules in the module communication system.
• SerialNormal: Serial non-procedure communication
• SerialNormal2: Serial non-procedure communication (Fxxx series method)
• SerialPlcLink: Serial PLC link (Omron PLC)
• SerialPlcLinkM: Serial PLC link (Mitsubishi PLC)
2: Registers any of the following I/O modules for Ethernet communication system
• TcpNormal: TCP non-procedure communication
• UdpNormal: UDP non-procedure communication
• UdpNormal2: UDP non-procedure communication (FXXX series method)
• UdpPlcLink: UDP PLC link (Omron PLC)
• UdpPlcLinkM: UDP PLC link (Mitsubishi PLC)
3: Registers one of the following I/O modules or no registration.
• EtherCAT: EtherCAT communication
• EtherNetIP: EtherNet/IP communication