Panasonic FP0R - Page 299

15-37
FP0R (A: Available, N/A: Not available)
Address Name Description
Read-
ing
Writ-
ing
DT90400
Elapsed value
area
Lower words
PLS-
CH0
Available for the transistor
output type only.
Note) When controlling the
pulse output CH by
F166(HC1S), F167(HC1R)
instructions, the target
value is stored.
The target value for match
ON/OFF is stored.
A A
DT90401 Higher words A A
DT90402
Target value
area
Lower words A N/A
DT90403 Higher words A N/A
DT90404
Target value
area for match
ON/OFF
Lower words A N/A
DT90405 Higher words A N/A
DT90406
Corrected
speed of initial
speed
Lower words
The initial speed of the
calculated result is stored. A N/A
DT90407
Deceleration
minimum
speed
The minimum speed for the
change of speed. A N/A
DT90408
Acceleration
forbidden area
starting
position
Lower words
If the elapsed value corsses
over this position when
changing the speed,
acceleration cannot be
performed.
A N/A
DT90409 Higher words A N/A
DT90410
Elapsed value
area
Lower words
PLS-
CH1
Available for the transistor
output type only.
Note) When controlling the
pulse output CH by
F166(HC1S), F167(HC1R)
instructions, the target
value is stored.
The target value for match
ON/OFF is stored.
A A
DT90411 Higher words A A
DT90412
Target value
area
Lower words A N/A
DT90413 Higher words A N/A
DT90414
Target value
area for match
ON/OFF
Lower words A N/A
DT90415 Higher words A N/A
DT90416
Corrected
speed of initial
speed
Lower words
The initial speed of the
calculated result is stored. A N/A
DT90417
Deceleration
minimum
speed
The minimum speed for the
change of speed. A N/A
DT90418
Acceleration
forbidden area
starting
position
Lower words
If the elapsed value corsses
over this position when
changing the speed,
acceleration cannot be
performed.
A N/A
DT90419 Higher words A N/A