Planmeca PlanMill 40 - Warnings and Precautions

Chapter A: General and technical data 4 Warnings and precautions
Technical manual Planmeca PlanMill 40 9
4 Warnings and precautions
The user must read and comply with all safety, warning, and instructional labels on the
Planmeca products.
Ensure that your Planmeca products are properly maintained through periodic
maintenance. If you suspect equipment malfunction or failure, discontinue using the
products and contact Planmeca After Sales immediately. Do not attempt to make any
repairs on Planmeca products.
Warning denotes something that can cause personal injury to the patient or the user.
Caution denotes something that can cause damage to the equipment.
This equipment is intended to be grounded. Connect the Planmeca products to earth
grounded outlet only. If a power cord (other than the one provided with the equipment) is
used for connecting to the power source, ensure it meets all of the following requirements:
• detachable power supply cord
•type SJT
•18 AWG
• 3 conductor
• rated 10 A or better
• For products outside of the United States and Canada, the power cord must be
marked “HAR” or with a suitable agency marking from the country of intended use.
The attachment plug and appliance coupler must be marked with a suitable agency
marking from the country of intended use.
WARNING
Failure to adhere to all safety warnings may result in personal injury, equipment
damage, or data loss.
WARNING
Do not use the Planmeca products for any purpose other than its intended and
labelled use.
WARNING
This is a Class A product. In a domestic environment this product may cause radio
interference in which case the user may be required to take adequate measures.
WARNING
When connecting the Planmeca components, use only the cables supplied with the
products. Failure to do so may result in increased electromagnetic emissions or
reduced immunity to external electromagnetic emissions.
WARNING
Do not make any unauthorized repairs or modifications to the system software or
hardware. This includes installing unauthorized software on the host computer sys-
tem or altering or bypassing any safety switches or mechanisms. Changes or modi-
fications not expressly approved by Planmeca could void the user’s authority to
operate the equipment.