Chapter E: Basic repair procedures 2 Basic repair procedures
Technical manual Planmeca PlanMill 40 141
Figure 145: Tool changer open warning message
3. Touch the NO button.
4. Warning that the mill is now in the Diagnostic Mode is shown.
Figure 146: Diagnostic mode warning
5. Touch OK button.
2.6.1 Raising Z-axis and setting Z-brake
To access the tool changer closed sensor it is necessary to raise the Z-axis and use the Z-
brake to hold the Z-axis in position.
1. Go to the Technician Console, High Level.
To Next Page
Loading...
