Planmeca PlanMill 40 - Page 24

Chapter B: Preventive maintenance
22 Planmeca PlanMill 40 Technical manual
• O-ring, small, cap
• Wrench, 12 mm, open end nsk spanner
• Wire brush, 8" long wooden handle
• Nozzle cleaning brush, pack of 10
• Twisted wire brush 4 mm
• Wire brush, spindle shaft
Figure 9: Planmeca PlanMill 40 technician 4 months maintenance kit
1 2 x Ellipsoidal milling bur (yellow
stripes)
2 2 x O-ring, small, cap
3 2 x IPS Empress CAD for PlanMill HT
A1 I12
4 2 x O-ring, large, cap