Table of contents
Technical manual Planmeca PlanMill 40 3
2.6.2 Adjusting tool changer close sensor position ................................................. 143
2.7 Nose seal ........................................................................................................................... 144
2.8 Tool bumber ....................................................................................................................... 145
2.9 Tool holder ......................................................................................................................... 147
2.10 Profile sensor ..................................................................................................................... 148
2.11 Circulation system .............................................................................................................. 150
2.11.1 Circulation pump ............................................................................................ 150
2.11.2 Water pressure switch .................................................................................... 153
2.11.3 Float switch .................................................................................................... 154
2.12 Pneumatics system ............................................................................................................ 155
2.12.1 Pneumatics assembly .................................................................................... 155
2.12.2 Pneumatics tubing routing ............................................................................. 158
2.12.3 Solenoid valve ................................................................................................ 159
2.12.4 Pilot valve ....................................................................................................... 160
2.12.5 Regulator, filter and water separator .............................................................. 161
2.12.6 Pressure multiplier ......................................................................................... 163
2.12.7 Air pressure switch ......................................................................................... 164
2.13 Motion base assembly repair .............................................................................................. 165
2.13.1 X-axis servo motor and coupling .................................................................... 165
2.13.2 Y-axis servo motor and coupling .................................................................... 168
2.13.3 Z-axis servo motor and coupling .................................................................... 172
2.13.4 Home and limit sensors identification ............................................................. 175
2.13.5 X-axis home sensor ....................................................................................... 176
2.13.6 X-axis limit sensor .......................................................................................... 177
2.13.7 Y-axis home and limit sensor ......................................................................... 178
2.13.8 Z-axis home and limit sensor ......................................................................... 180
2.13.9 Spindle and spindle motor ............................................................................. 182
2.13.10 Spindle housing ............................................................................................. 195
2.13.11 Quick release adapter .................................................................................... 197
2.14 Software configuration ........................................................................................................ 199
2.14.1 Pulling log files ............................................................................................... 199
2.14.2 Installing software/firmware ............................................................................ 199
2.14.3 PlanMill 40 touch screen calibration ............................................................... 199
To Next Page
Loading...
