Planmeca PlanMill 40 - Page 85

Chapter D: Troubleshooting
Technical manual Planmeca PlanMill 40 83
Milling unit does not power up
Power cable unplugged Plug power cable into ac power source.
Main power supply switch is
“OFF”
Toggle “ON” main power supply.
Main power fuse is blown Replace main power fuse:
2.2.5 "Fuse power entry module" on page 106
Defective power supply
module
Replace power supply module:
2.2.1 "Power supply module" on page 100
Defective main power
assembly (lower ebox)
Replace lower e-box:
2.2.9 "Lower electronics box (E-box)" on page 113
Symptom Problem Solution