8.48
9929419 R02 - 2018-2019 RZR XP / XP 4 Turbo S Service Manual
© Copyright Polaris Industries Inc.
35.Depress shaft assembly deep enough so that
negative spring assembly is just below inner body
top.
36.Slide bearing assembly into position seated on inner
body.
37.Remove cinch ring from assembly and wipe out all oil
residue.
38.Clean cinch ring thoroughly.
39.Run cinch ring down to the bottom thread on bearing
assembly.
40.Install retaining ring, ensuring that it is fully seated in
ring gland.
41.Holding cinch ring spanner, torque bearing assembly
to specification.
TORQUE
Shock Bearing Assembly:
35 ft-lb (47 Nm)
42.On 2.5 Bypass shocks with Aluminum body, apply
290 wicking Loctite to bearing assembly threads. 3.0
Bypass shocks with steel outer bodies do not require
290 Loctite on the bearing assembly threads.
NOTE
On remote reservoir assemblies, lubricate o-rings with
Slick Honey prior to installing hose assembly. With hose
fully seated install retaining ring, Ensure retaining ring is
fully seated by pulling back on hose.
43.With shaft full extended, remove bleed screw and o-
ring.
44.Always set IFP with a down motion of IFP tool. (oil
should be above IFP when completed). Refer to the
Shock Specifications tables at the beginning of this
section for proper IFP depth.
45.After setting IFP depth, install Bleed screw with o-
ring.
STEERING / SUSPENSION
To Next Page
Loading...
Need help?
General
