Quantum Scalar 1000 - Page 260

7-8 Error Messages
6-00054-02 Rev A
14 Cannot read the Serial Number label during a Teach operation.
Action 1
Check the Serial Number barcode label to make sure that it is installed properly
and not damaged or dirty. The Serial Number barcode label is located on the
lower right corner of the first 5x10, 5x12, or 5x15 Storage Assembly in the CM
(below the Teach Master barcode label). The Serial Number barcode label
contains a barcode and readable serial number. Example: 201100031.
Action 2
If the problem is not corrected or persists, contact ATAC. For contact
information, refer to ADIC Technical Assistance Center on page 1-5.
15 The Barcode scanner is not capable of fully supporting all different labels in
a Mixed-Media Library.
Action 1
Contact ATAC. For contact information, refer to ADIC Technical Assistance
Center on page 1-5.
20 Serial Port Connection failures.
Action 1
Contact ATAC. For contact information, refer to ADIC Technical Assistance
Center on page 1-5.
21 NVRAM failures.
Action 1
Contact ATAC. For contact information, refer to ADIC Technical Assistance
Center on page 1-5.
22 Failure to communicate with the Operator Panel.
Action 1
Contact ATAC. For contact information, refer to ADIC Technical Assistance
Center on page 1-5.
23 An unexpected interrupt is received.
Action 1
Contact ATAC. For contact information, refer to ADIC Technical Assistance
Center on page 1-5.
Table 7-1 SAC Reporting (Continued)
Reported
SAC
Perform these actions