R&S FSV3000 Series - Page 639

General Instrument Setup
R&S
®
FSVA3000/ R&S
®
FSV3000
639User Manual 1178.8520.02 ─ 01
Select "Test Connection" on page 625 to establish a temporary connection from the
R&S FSV/A to the specified signal generator.
If a connection to a signal generator is already configured, the connection data is provi-
ded for information only.
Remote command:
CONFigure:GENerator:IPConnection:ADDRess on page 1135
Connect/Disconnect
The R&S FSV/A attempts to establish a connection to the signal generator, or discon-
nects it.
If an instrument is connected, the following information is displayed:
●
Device type
●
Name and serial number
●
Connection state
Note: While the SCPI Recorder is enabled with generator control, you cannot discon-
nect the generator.
Remote command:
CONFigure:GENerator:CONNection[:STATe] on page 1134
CONFigure:GENerator:CONNection:CSTate? on page 1134
Coupling State
Enables or disables coupling between the R&S FSV/A and a connected signal genera-
tor.
Remote command:
INSTrument:COUPle:GENerator:STATe on page 1152
Center Frequency
Couples the center frequency of the connected signal generator to the R&S FSV/A.
This setting requires the Coupling State to be enabled.
Remote command:
INSTrument:COUPle:GENerator:CENTer[:STATe] on page 1151
Generator Frequency Offset
Defines a fixed offset to the center frequency of the R&S FSV/A for the coupled signal
generator.
This setting requires the Coupling State to be enabled.
Remote command:
INSTrument:COUPle:GENerator:CENTer:OFFSet on page 1150
Reference level
Couples the reference level of the connected signal generator to the R&S FSV/A.
This setting requires the Coupling State to be enabled.
Remote command:
INSTrument:COUPle:GENerator:RLEVel[:STATe] on page 1151
Synchronizing Measurement Channel Configuration