Renesas PG-FP6 V1.06

PG-FP6 V1.06 Terminology
R20UT4469EJ0800 Rev.8.00 Page 17 of 188
Oct.01.21
Term
Meaning
Parameter file
Information file specific to the target device (file extension: *.pr5 or .pr6). This file is for
use by the FP6 Terminal and PG-FP6 main unit.
Each parameter file holds parameter information required for programming of the flash
memory in the target device.
Programming area
Area in the FP6 main unit for saving the parameter, settings, and program files
FINE
Single- or dual-line communications interface operating through the FINE pins of an
MCU. Some of our MCUs support programming via single-line FINE.
ID authentication mode
One of the security features of the MCU. Connection of the flash programmer is
protected by ID authentication.
For details, refer to the user’s manual of the MCU.
Command protection mode
One of the security features of the MCU. Execution of individual commands (e.g., the
erase command) can be restricted.
For details on operations while the security feature is enabled, refer to the user’s manual
of the MCU.
TSIP
Dedicated hardware secure IP (Trusted Secure IP) for managing encryption keys. For
details, contact a Renesas Electronics sales office.
ID Tag
Data for programming in the data flash memory of some V850 target devices. For
details, refer to the user’s manual of the target device.
Renesas Partition Data File
File including the information on the boundary setting output from the e
2
studio for the
RA family