Renesas PG-FP6 V1.06

PG-FP6 V1.06 7. Usage of Communications Commands
R20UT4469EJ0800 Rev.8.00 Page 80 of 188
Oct.01.21
Table 7.2 List of FP6 Device Commands
Command Name
Description
bln
Executes the blank check.
clr Executes the Configuration clear.
con
Executes the processes from “transition to flash memory programming mode” to “signature
verification”.
dcon Executes the termination of the flash memory programming mode.
dlm
Refers to the DLM state and causes a transition of the state.
ep Executes erasure and then programming.
ers
Executes the Erase command.
ers_chip Initializes the target device.
gdi
Gets the information of blank check and flash option.
ged Gets the information of endian.
gid
Gets the ID code.
glb Gets the information of lock bit.
gob
Gets the information of option byte.
gof Gets the information of OFS.
gos
Gets the information of flash option.
got Gets the information of OTP.
gsc
Gets the information of security.
gtm Gets the information of Trusted Memory.
idc
Executes the ID code setting.
opb Executes the option byte setting.
otp
Executes the OTP setting.
pfo Sets the flash options collectively.
prg
Executes programming.
read Reads the flash memory data from the target device.
rsc
Executes the Security Release command.
scf Executes the [Set Security] command.
sed
Executes the endian setting.
sid Sets the ID code and enables ID authentication in the serial programming mode.
sig
Executes the Signature read command.
slb Executes the lock bit setting.
spd
Disables the serial programming.
stm Executes the Trusted Memory setting.
sum
Executes the Checksum command.
vrf Executes the Verify command.