20-2 Index Rexroth IndraDrive
DOK-INDRV*-SYSTEM*****-PR02-EN-P
conditions
ambient 5-4
storage 5-3
transport 5-3
connecting HAS04 14-51
connecting motor blowers 7-24
connection elements 7-32
connection of motor cable to drive controller 7-28, 7-32
connection point of equipment grounding conductor 12-2
connection technique 14-56
contact-welded connections 13-1
contents of project planning manual for system 1-1
contents of project planning manuals 1-6
continuous regenerative power
calculate 15-8
control cabinet
arrangement of components 7-17
multiple-line structure 7-17
control cabinet adapter 14-45
control cabinet grounding 7-21
control cabinet mounting 7-1
control cabinet with multiple-line structure 7-17
control circuits for the mains connection 11-1
control section 1-13
control section option 6-20
control voltage 24V 5-7
control voltage connection 12-8
control voltage or auxiliary voltage connection 7-25
cooling units 7-18
C-UL-US listing 5-1
current reduction in the case of overtemperature 15-17
D
data
ambient 5-4
data of motor power cable 5-9
DC bus connection 12-5
DC bus continuous power
calculate 15-1
main drives 15-4
servo drives 15-3
DC bus peak power
calculate 15-4
DC bus short circuit 15-18
deceleration 11-7
degree of protection 5-4
derating 5-5
design and installation in interference-free area of control cabinet (area A) 7-24
design and installation in interference-susceptible area of control cabinet (area B)
7-25
design and installation in strongly interference-susceptible area of control cabinet
(area C) 7-26
determining the data for selecting the 24V supply 15-17
device depths 7-4
device depths and device heights 7-3
device heights 7-4
device widths 7-4
dimensions 7-3
discharging device 19-5
discharging of DC bus capacitors 19-4
Disposal 17-1
dissipation heat
reduce 15-6
distance between drive controllers 7-5
distances for drive controllers 7-5
distances on top and bottom of drive controllers 7-6
distortion factor 15-11
division into areas (zones) 7-22
docu house 1-6
To Next Page
Loading...
