Message Problem and solutions
add_sess_IPv6: community <community name>
already defined.
The same community name already exists. Use
another community name.
add_sess_IPX: bad trap <IPX address>
community <community name>
The IPX address (00:00:00:00:00:00) is
unavailable when the community access type is
TRAP. Specify the host IPX address for the TRAP
destination.
add_sess_IPX: community <community name>
already defined.
The same community name already exists. Use
another community name.
adjust time server <NTP server name> offset: xx sec. ncsd tells you the timing of the NTP server and
whether or not the time system clock is set.
NTP Server: NTP server name
offset: number of seconds of delay (minus number
if a time in advance is specified)
ANONYMOUS FTP LOGIN FROM <IP address>,
<password>
An anonymous user logged in from the post <IP
address> using the password <password>.
Attach FfileSserver=<file server> Connection to the file server as the nearest server
has been established.
Attach to print queue <print queue name> The system attached to the print queue when the
print server goes online.
authenticating The supplicant is authenticating with the access
point (EAP or WPA).
authentication mode mismatch The authentication mode of the access point is
different from the authentication mode of the
supplicant.
Use the authentication mode between the access
point and the supplicant.
child process exec error ! The network service failed to start. Turn the printer
off and then on. If this does not work, contact your
service or sales representative.
cipher suite mismatch The uni-cast/multi-cast suite (TKIP/AES/WEP) of
the access point is different from the suite used by
the supplicant.
4. Monitoring and Configuring the Printer
230
To Next Page
Loading...
Need help?
General
