For details about how to specify the path using Browse Network, see "Locating the SMB folder using
Browse Network".
17. Press [Connection Test] to check the path is set correctly.
18. Press [Exit].
If the connection test fails, check the settings, and then try again.
19. Press [OK].
20. Press [Exit].
21. Press the [User Tools/Counter] key.
• To register the name, see "Registering Names".
• You can enter up to 64 characters for the user name.
• You can enter up to 64 characters for the password.
• You can enter a path using up to 128 characters.
• If User Authentication is specified, contact your administrator.
• p.245 "Registering Names"
Locating the SMB folder manually
This section describes how to locate the SMB folder manually.
1. Press [Change] under "Path".
2. Enter the path where the folder is located.
3. Press [OK].
If the format of the entered path is not correct, a message appears. Press [Exit], and then enter the
path again.
• Enter the path using this format: "\\ServerName\Share- Name\PathName".
• You can also enter an IPv4 address.
• You can enter a path using up to 128 characters.
Locating the SMB folder using Browse Network
This section describes how to locate the SMB folder using Browse Network.
5. Registering Addresses and Users for Facsimile/Scanner Functions
278
To Next Page
Loading...
Need help?
General
