Risco ProSYS Plus - Page 111

11
/
2017 Page 111 5IN2413 B
Quick keys Parameter Default Range
ZZZ

Entry Follower + Stay
All
Assigned to motion detectors and to interior doors protecting the area
between the entry door and the keypad, as follows:
• In partial (Stay) arming mode, a zone(s) given this designation behaves
like an Exit/Entry zone and is subject to the Entry and Exit Delay time
periods specified under Exit/Entry Delay 1. See Exit/Entry Delay 1,
above (
ZZZ) and .
• In full (Away) arming mode, a zone(s) given this designation behaves
like an Entry Follower Zone and causes an immediate intrusion alarm
when violated unless an Exit/Entry zone was violated first.
• If so, an Entry Follower + Stay zone(s) remains bypassed until the end
of the Entry Delay period.
ZZZ

Key Switch Delay
Used to apply the Exit/Entry Delay 1 parameter to the momentary key
switch operation. See Exit/Entry Delay 1, above (
ZZZ) and
.
ZZZ

Latch Key Switch Delay
Used to apply the Exit/Entry Delay 1 parameter to the latched key switch
operation. See Exit/Entry Delay 1, above (ZZZ) and
.
ZZZ

Tamper
For tamper detection. This zone operates the same as 24 hours zone, but it
has a special reporting code.
Note
For this zone type the zone sound is determined according to the Tamper
Sound defined under 1) System  4) Sound  1) Tamper
ZZZ

Technical
This zone operates the same as 24 hours zone, its report code should be
manually set according to the relevant detector connected to the zone.