Risco ProSYS Plus - Page 141

11
/
2017 Page 141 5IN2413 B
 xx  
Bell Follow
This output enables the connection of different external sounders to
different partitions. Activates the output when one of the defined
partitions is in alarm mode and the bell is triggered. It will be activated for
the programmed bell time or until the alarm is unset.
Note
The external sounder will not generate any squawk sounds
 xx  
Bell Stay Off
This parameter causes the output to function as follows:
• In full (Away) arming mode, the output will follow the bell activation
in the defined partitions.
• In partial (Stay) arming mode, the output will not be activated.
N
ote
I
f an alarm occurs in a zone that shares more than one partition and one of
t
he partitions is in full (Away) arming mode (while the other is in partial
(
Stay) arming mode, the output will be activated, as described above.
• In partial (Stay) arming mode, a 24-hour zone will not activate this
output.
 xx  
Zone Bypass
Activates the output when the relevant partitions are in full (Away)
arming mode or partial (Stay) arming mode, and any zone in the relevant
partitions is bypassed.
 xx  
Automatic Arm Alarm
Activates the utility output when there is a not ready zone at the end of the
pre warning time during an auto-arm process. The output restore shall be
on Bell- Timeout or at user Disarm.
 xx  
Zone Loss Alarm
Activates the utility output when there is a lost wireless zone in the
system. The output restore shall be on Bell-Timeout or at user Disarm.