11
2017 Page 165 5IN2413 B
Quick Keys Parameter
2. GPRS/IP: The panel checks for the availability of the GPRS
network. During regular operation mode all calls and data
transmission are carried out using the GPRS. In the case of
trouble the report is routed to the IP network.
3. IP Only: The report is executed through the IP network only.
4. GPRS Only: The report is executed through the GPRS network.
Enter the relevant IP and Port numbers for the MS that will
receive reports from the system (See IP and Port)
–
SMS
Enter the relevant phone numbers for the monitoring station that
will receive reports from the system via encrypted SMS (see
explanation in Voice type, above)
Events are sent to the monitoring station using encrypted SMS
messages (128 BIT AES encryption). Each event message contains
information including the account number, report code,
communication format, time of event and more. The event
messages are received by RISCO’s IP Receiver software located at
the monitoring station site. The IP Receiver translates the SMS
messages to standard protocols used by the monitoring station
applications (For example; contact ID).This channel requires that
RISCO Group’s IP/GSM receiver has to be used at the MS side.
LRT
The LRT menu contains parameters for setting a system long-range
radio communication network, using the Location Aided Routing
(LARS) protocol (LARS, LARS1, or LARS2) or E-LINE protocol to
facilitate detailed event transmission to monitoring stations.
SIA IP
NOTE: = monitoring station (MS) account
Reports to the monitoring station can be transmitted using the SIA
IP protocol to standard SIA IP receivers. Using SIA IP enables
transmission of visual imagery from PIR cameras. Reporting by SIA
IP can be established through the hardware channels installed in
your system. Reporting of the SIA IP is 128 BIT AES encrypted. SIA
IP reports also support labels reporting. Usage of SIA IP requires
setting. See:
• Encryption Key
• SIA IP Receiver Number
• SIA IP Receiver Line Number
To Next Page
Loading...
