Risco ProSYS Plus - Page 167

11
/
2017 Page 167 5IN2413 B
Quick Keys Parameter
 
Partition (MS Accounts per Partition)
You can specify the monitoring station account(s) to notify upon
events that occur for the partitions you select (there are 32 partitions
maximum per system).
If you selected partition(s) from 1—3, you then choose the monitoring
station account(s) to notify (1—3) for each, followed by entering the
respective account numbers (codes).
If you selected partition(s) from 4—32, you then enter the account
numbers (codes); all monitoring station accounts will be automatically
notified for events occurring in these partitions.
 To designate MS accounts per partition:
1. From the installer Programming menu, go to: 5  2  2
(Communication MS  Accounts)
2. Scroll to 01)Partition, and then press OK ().
3. Select a partition number and then press OK.
4. [If you selected partition 1—3]: Scroll to the MS account (
,  or
), press OK, enter the MS account number (code), and press OK.
5. [If you selected partition 4—32]: Enter the MS account number
(code) and press OK.
6. Repeat this procedure for all additional monitoring station
accounts-per-partition designations
NOTE: Advanced configuration options are also available from the
Configuration Software.
Communication  Monitoring Station  Communications Format
Quick Keys Parameter

Communications Format
Enables the system to communicate to the monitoring station.
Note
See Appendix E:
Library Voice Messages, page 234.
 Contact ID: The system allocates Report Codes supporting Contact
(Point) ID
 SIA: The system allocates Report Codes supporting SIA (Security
Industry Association) format