11
2017 Page 80 5IN2413 B
Quick keys Parameter Default Range
TX Supervise
058 1-255 minutes
Specifies how often a 2-way wireless device generates a supervision request
to the system. If any accessory doesn’t respond to the request at least once
during the RX Supervision time, the system will regard the accessory as Lost.
Note
Device will generate the supervision message according to the time defined.
Important
The RX Supervision time should be higher than the TX Supervision time in
order to eliminate a false lost event.
Service Mode
020 1–255 minutes
The time period that all tampers (main unit and accessories) can be opened
for purposes of battery replacement without triggering a tamper alarm.
AC Off Delay
30 000–255 minutes
In the case of a loss of AC power, this parameter specifies the delay period
before reporting the event or operating the programmable output. If the
delay time is set to zero, there will be no delay period.
Guard Delay
30 01–99 minutes
Specifies the time period that the system will be unarmed after an authorized
user enters a Guard code.
Swinger Limit
00
00–15 times
A swinger is a repeated violation of the same zone, often resulting in a
nuisance alarm and usually due to a malfunction, an environmental
problem, or the incorrect installation of a detector or sensor. This parameter
specifies the number of violations of the same zone reported during a single
armed period, before the zone is automatically bypassed.
Notes
• Enter 00 to disable the swinger shutdown.
• EN 50131 compliance with swinger limit of no more than 10 times
Redial Wait
30 0–255 seconds
The number of seconds between attempts at redialing the same phone
number. Applies to the parameter MS Retries, page 169, and Follow Me
Retries, page 187.
Last Exit Sound
10 01–255 seconds
Defines the final seconds of the Exit Time for which the beep sound will
change (at keypads), indicating that Exit Time period is about to expire.
To Next Page
Loading...
