Rohde & Schwarz SMBV100A - Working with List Editor

Manual Operation
R&S
®
SMBV100A
84Operating Manual 1407.6062.32 ─ 08
Internally generated data lists can be used for digital modulation and digital standards;
the same applies to internally defined control and marker signals.
The lists are saved to files and may thus have any length. The file name of the lists and
the directory to which the files are saved are user-selectable. The file prefix is different
for each list type and is permanently assigned by the system.
For information about file handling and overview of the automatically assigned file pre-
fixes, refer to chapter 4.7, "File Management", on page 91.
4.5.1 Working with List Editor
The "User Correction" and "List Mode" dialogs provide a list editor for defining the fre-
quency/level value pairs.
Editing list mode data lists
1. To access a list editor and open an existing data list for editing, use the cursor keys
to select the associated button "Edit User Correction Data..." or "Edit List Mode
Data..." (if available) in the individual menu.
The selected list is displayed and the cursor marks the first row of the "Frequency/
Hz" column.
If no list has been selected, a blank list of only one row is displayed.
2. Press the LEFT/RIGHT arrow keys to change between the colums.
Use the UP/DOWN arrow keys to mark a row.
3. Use the numeric keys to enter the value for the value pairs in the "Frequency/Hz" and
"Power/dBm" table columns. A blank row is inserted at the end of the list.
An existing list can be edited in the insert or overwrite mode; use the INSERT key to
toggle between this two modes.
Terminate the entry by pressing a UNIT key.
4. To select a row, select the "GoTo" button and press the ENTER key.
Use the numeric keys to enter the row index in the entry field and press the
ENTER key to confirm the entry.
Editors