Instrument Function
R&S
®
SMBV100A
116Operating Manual 1407.6062.32 ─ 08
Current Sensors
Section "Current Sensors" lists the sensors that are connected to the generator and indi-
cates their serial number, the revision state and some features.
SCPI command:
SENSe<ch>[:POWer]:TYPE on page 492
SENSe<ch>[:POWer]:SVERsion on page 492
SENSe<ch>[:POWer]:SNUMber on page 491
Update
Section "Update" provides access to the file system in order to select a file for an R&S
NRP sensor update (Button "Select NRP File"), the selected file is indicated to the left of
the button. On the left side, the sensor to be updated is selected.
Button "Run Update" starts the update. If the update is interrupted for example by acci-
dently pulling off the sensor, selection "Rescue" is offered to restart the update process.
Prerequisite is that no other sensor is connected to the instrument.
The procedure is as follows:
●
Do not reconnect the sensor but keep it ready to be connected
●
Select "Rescue" in the left sensor selection field
●
Activate "Run Update"
●
Confirm query in message box
●
Connect sensor within 4 seconds
The update starts, a bar informs about the progress.
SCPI command:
n.a.
5.2.3.7 Delete Temporary Files
To maintain sufficiant amount of free disc space on the internal flash memory, the R&S
Signal Generator provides a convenient way to delete the temporary files from the direc-
tory /var/smbv/unicod.
General Instrument Settings
To Next Page
Loading...
