Rohde & Schwarz SMBV100A - Signal Output

Instrument Function
R&S
®
SMBV100A
269Operating Manual 1407.6062.32 ─ 08
Sample Rate Value - Digital I/Q Output
Sets or displays the sample rate of the digital I/Q output signal, depending on the selected
sample rate "Source".
SCPI command:
[:SOURce<hw>]:IQ:OUTPut:DIGital:SRATe on page 646
5.7.3 Signal Output
The level of the output signal is set in the "Signal Output" section. For entering the value,
level type "PEP" or "Level" can be selected.
Set Level Via - Digital I/Q Out
Selects the level type (PEP/Level) that is used to set the signal level. Either the PEP or
the Level entry field can be edited.
SCPI command:
[:SOURce<hw>]:IQ:OUTPut:POWer:VIA on page 646
PEP - Digital I/Q Out
The signal level is expressed in terms of a peak envelope power value (PEP).
The level entry fields and the corresponding units are displayed in the status bar. The
level display always refers to both signal components (SQR(I
2
+Q
2
)).
SCPI command:
[:SOURce<hw>]:IQ:OUTPut:DIGital:POWer:PEP on page 645
Level - Digital I/Q Out
The signal level is expressed in terms of an rms level value.
The level entry fields and the corresponding unit are displayed in the status bar. The level
display always refers to both signal components (SQR(I
2
+Q
2
)).
SCPI command:
[:SOURce<hw>]:IQ:OUTPut:DIGital:POWer:LEVel on page 644
5.7.4 User Variation
If the level is set using the rotary knob, the step width is defined in the User Variation
section.
Variation Active - Digital I/Q Out
Activates the user-defined step width that is used by varying the level value with the rotary
knob.
"On"
The level value set with the rotary knob is varied using the user-defined
step width which is entered under "Variation Step".
Digital I/Q Output Settings