Remote Control Commands
R&S
®
SMBV100A
469Operating Manual 1407.6062.32 ─ 08
Usage: Query only
:HCOPy:FILE[:NAME]:AUTO[:FILE]:DAY:STATe <State>
This command activates the usage of the day in the automatic file name.
Parameters:
<State> 0 | 1 | OFF | ON
*RST: ON
Example:
HCOP:FILE:AUTO:DAY:STAT OFF
deactivates the use of the day in the automatically generated file
name.
:
HCOPy:FILE[:NAME]:AUTO[:FILE]:MONTh?
This command queries the month in the date part in the automatic file name.
Return values:
<Month> float
Example:
HCOP:FILE:AUTO:MONT?
queries the month in the date part in the automatic file name.
Usage: Query only
:HCOPy:FILE[:NAME]:AUTO[:FILE]:MONTh:STATe <State>
This command activates the usage of the month in the automatic file name.
Parameters:
<State> 0 | 1 | OFF | ON
*RST: ON
Example:
HCOP:FILE:AUTO:MONT:STAT OFF
deactivates the usage of the month in the automatic file name.
:HCOPy:FILE[:NAME]:AUTO[:FILE]:NUMBer?
This command queries the number in the automatic file name. The number is assigned
in such a way that always the lowest possible value for an unique file name within the
selected path is used.
On initially switching on the device the number will be reset to the lowest possible value.
Starting with number 0 the output directory will be scanned for already existing files. As
long as files with the same name are existing the number will be incremented by 1. The
number will be automatically set to a number so that the resulting file name will be unique
within the selected path. The current number will not be saved in the save recall file but
will be temporarily stored within the database. On subsequent saves the number will be
incremented.
HCOPy Subsystem
To Next Page
Loading...
