Rohde & Schwarz SMBV100A - Switching to Manual Control - Local Key

Instrument Function
R&S
®
SMBV100A
133Operating Manual 1407.6062.32 ─ 08
5.2.4 Switching to Manual Control - Local Key
In remote control mode a status message appears in the display header. The rest of the
display remains unchanged and shows the current instrument status, i.e. the status which
exists under the remote control settings. The instrument can be operated (e.g. menus
can be opened). However, it is not possible to enter or change values.
The status message additionally indicates whether the LOCAL key is disabled or enabled.
See also chapter 6.2.1, "Switching to Remote Control", on page 400.
If the "REMOTE" status message is shown, the LOCAL key switches the instrument from
remote control to manual control. The current command must be fully processed before
the mode is switched, otherwise the instrument switches immediately back to remote
control.
If the "REM-LLO" status message is displayed, the instrument can be switched from
remote control to manual control by means of remote control only (e.g. with the Visual
Basic command CALL IBLOC (generator%)); the LOCAL key is disabled. The key is
disabled by remote control with the command LLO.
When switching from remote to manual control, the display update suppression function,
if active ("SETUP > GUI Update" is Off), is automatically deactivated ("SETUP > GUI
Update" is On).
5.2.5 Generating a Hard Copy of the Display
The HCOPY key opens a window for configuring the hardcopy setting, like output file
format, path and file name.
General Instrument Settings