Instrument Function
R&S
®
SMBV100A
115Operating Manual 1407.6062.32 ─ 08
"Option"
Displays the option short designation.
Tip: Open the "Setup > Software/Options" dialog to retrieve more infor-
mation about the installed options.
"License
Count"
Displays the number of the licenses for the selected option key.
"License Type"
Display the type of license.
A license type is a joint qualification for the duration of applicability and
the portability of a license. The following license types are provided:
evaluation, permanent, portable, quantified, timed with duration of 1, 3,
6 or 12 months. A license can also be in the states deactivated and
expired.
For time limited licenses, the left time of applicability is displayed too.
"Manage"
Opens the "Waveform Packages License" dialog (see Manage Wave-
form Packages).
5.2.3.5
Gui Update
The "Start/Stop Gui Update" dialog provides the possibility to switch off update of the
displayed parameters in order to increase speed for certain settings.
The indicated values are not updated and may therefore differ from the intern, used val-
ues.
On/Off GUI Update
Switchs on/off update of the displayed parameters.
Switching off the update of the displayed parameters increases the speed for certain
settings.
Note: It is especially recommended to switch off the GUI update for optimum sweep
performance with short dwell times and for fast settling times.
SCPI command:
:SYSTem:DISPlay:UPDate on page 712
5.2.3.6 NRP-Z Info/Update
In the "NRP-Z Info/Update…" dialog, the connected power sensors are indicated together
with their serial number, revision state and features. The software of a connected sensor
can be updated to a new version.
To access the "NRP-Z Info/Update…" dialog, select "System" and press the SETUP or
MENU key.
General Instrument Settings
To Next Page
Loading...
