Rohde & Schwarz SMBV100A - Output Subsystem

Remote Control Commands
R&S
®
SMBV100A
482Operating Manual 1407.6062.32 ─ 08
:MMEMory:MSIS <Msis>
The command is without effect for the Linux operating system.
Usage: SCPI confirmed
:MMEMory:RDIRectory <Rdirectory>
Removes an existing directory from the mass memory storage system. If no directory is
specified, the subdirectory with the specified name is deleted in the default directory.
Setting parameters:
<Rdirectory> string
String parameter to specify the directory to be deleted.
Example:
See "Working with Files and Directories" on page 476.
Usage: Setting only
:MMEMory:STORe:STATe <sav_rcl_state_number>, <file_name>
Stores the current instrument setting in the specified file.
The instrument setting must first be stored in an internal memory with the same number
using the common command *SAV.
Setting parameters:
<sav_rcl_state_number>Corresponds to the specific <number> defined with the *SAV
command, e.g. *SAV 4.
<file_name> String parameter to specify the file name with extension
*.savrcltxt.
Example:
See "Storing and Loading Current Settings" on page 476.
Usage: Event
7.12 OUTPut Subsystem
The OUTPut system contains the commands which set the properties of the RF
OUTPUT connectors and USER connectors.
The properties of the LF output connector are set in the chapter 7.14.11,
"SOURce:LFOutput Subsystem", on page 647 system.
:OUTPut<hw>:AFIXed:RANGe:LOWer.............................................................................483
:OUTPut<hw>:AFIXed:RANGe:UPPer..............................................................................483
:OUTPut<hw>:AMODe...................................................................................................483
:OUTPut<hw>:IMPedance..............................................................................................484
:OUTPut<hw>:PROTection:CLEar...................................................................................484
:OUTPut<hw>:PROTection:TRIPped................................................................................484
:OUTPut<hw>[:STATe]...................................................................................................484
OUTPut Subsystem