Rohde & Schwarz SMBV100A - Source:bb:graphics Subsystem

Remote Control Commands
R&S
®
SMBV100A
584Operating Manual 1407.6062.32 ─ 08
Usage: Setting only
7.14.3.4 SOURce:BB:GRAPhics Subsystem
This subsystem contains the commands used to setup the graphical display.
[:SOURce<hw>]:BB:GRAPhics:MODE.............................................................................584
[:SOURce<hw>]:BB:GRAPhics:SMARt:STATe..................................................................584
[:SOURce<hw>]:BB:GRAPhics:SRATe:MODE..................................................................584
[:SOURce<hw>]:BB:GRAPhics:SRATe:USER...................................................................585
[:SOURce<hw>]:BB:GRAPhics:STATe.............................................................................585
[:SOURce<hw>]:BB:GRAPhics:TRIGger:SOURce.............................................................586
[:SOURce<hw>]:BB:GRAPhics:MODE <Mode>
Selects the graphical signal display.
Parameters:
<Mode> IQ | VECTor | CCDF | PSPectrum | CONStellation | EYEI |
EYEQ
*RST: IQ
Example:
BB:GRAP:MODE VECT
selects vector diagram.
[:SOURce<hw>]:BB:GRAPhics:SMARt:STATe <State>
Activates/deactivates the "smart graphics".
Parameters:
<State> 0 | 1 | OFF | ON
*RST: 0
Example:
BB:GRAP:SMAR:STAT ON
Activates smart graphics.
[:SOURce<hw>]:BB:GRAPhics:SRATe:MODE <Mode>
Sets how the time resolution of the signal is determined. Maximum resolution corre-
sponds to a display covering the entire signal bandwidth. The higher the resolution is, the
shorter the length of the displayed signal segment will be for the specified recording
depth.
SOURce Subsystem