Remote Control Commands
R&S
®
SMBV100A
705Operating Manual 1407.6062.32 ─ 08
Parameters:
<Ntransition> string
Example:
STAT:OPER:NTR 0
A transition from 1 to 0 in the condition part of the Status:Ques-
tionable register does not cause an entry to be made in the EVENt
part.
Usage: SCPI confirmed
STATus:QUEStionable:PTRansition <Ptransition>
The command sets the bits of the NTRansition part of the STATus:QUEStionable register.
If a bit is set, a transition from 1 to 0 in the condition part causes an entry to be made in
the EVENt part of the register.
Parameters:
<Ptransition> string
Example:
STAT:OPER:PTR 32767
All transitions from 0 to 1 in the condition part of the Status:Ques-
tionable register cause an entry to be made in the EVENt part.
Usage: SCPI confirmed
STATus:QUEue[:NEXT]?
The command queries the oldest entry in the error queue and then deletes it. Positive
error numbers denote device-specific errors, and negative error numbers denote error
messages defined by SCPI. If the error queue is empty, 0 ("No error") is returned. The
command is identical to SYSTem:ERRor?
Return values:
<NEXT> string
Example:
STAT:QUE
queries the oldest entry in the error queue.
Response: 0, 'no error'
No errors have occurred since the error queue was last read out.
Usage: Query only
SCPI confirmed
7.16 SYSTem Subsystem
The SYSTem subsystem contains a series of commands for general functions which do
not directly affect signal generation.
:SYSTem:BEEPer:STATe...............................................................................................706
:SYSTem:COMMunicate:GPIB:LTERminator....................................................................707
:SYSTem:COMMunicate:GPIB[:SELF]:ADDRess..............................................................707
SYSTem Subsystem
To Next Page
Loading...
