Rohde & Schwarz SMBV100A - 7.4 Calibration Subsystem; C Alibration: a LL[: M Easure]; Calibration Subsystem

Remote Control Commands
R&S
®
SMBV100A
456Operating Manual 1407.6062.32 ─ 08
If you want to write an ASCII C-List directly without using the C-List editor, a special syntax
has to be taken into account:
●
The tag and the following [state: start time]-pairs are separated by a colon ":".
●
The [state: start time] pairs in turn are separated by semicolons ";".
●
The list state can be either 0 or 1.
●
The time unit is the simple period.
Example:
"CW MODE LIST 0:0;380:1" for a CW trace:
The list status starts at time 0 with 0, and at time point 380 symbol periods after start, it
changes to 1.
With the commands BB:DM:CLISt:... you can also generate control lists in binary
fomat, if required. See "DM Lists" on page 572.
7.4 CALibration Subsystem
The CALibration system contains the commands for adjustment. Adjustment is triggered
by the query commands. The response "0" indicates error-free adjustment, and the
response "1" means that an error occurred during adjustment.
:CALibration:ALL[:MEASure]...........................................................................................456
:CALibration<hw>:FMOFfset[:MEASure]...........................................................................457
:CALibration<hw>:FREQuency[:MEASure].......................................................................457
:CALibration<hw>:IQModulator:FULL...............................................................................457
:CALibration<hw>:IQModulator:LOCal..............................................................................457
:CALibration<hw>:LEVel:ALCTable[:MEASure].................................................................458
:CALibration<hw>:LEVel[:MEASure]................................................................................458
:CALibration<hw>:LEVel:EXTern:DATA............................................................................458
:CALibration<hw>:LEVel:STATe......................................................................................459
:CALibration:ALL[:MEASure]?
The command starts all internal adjustments for which no external measuring equipment
is needed.
Return values:
<Measure> 0 | 1
Example:
CAL:ALL:MEAS?
starts the adjustment of all functions for the entire instrument.
Response: "0"
adjustment has been performed successfully.
Usage: Query only
SCPI confirmed
CALibration Subsystem