Instrument Function
R&S
®
SMBV100A
326Operating Manual 1407.6062.32 ─ 08
Memory Size 128 MB
Waveform Length (with 2 markers) 128 MB / 4.25 bytes ( 30 MSamples
Maximal Waveform Length 128 MB / 4 bytes = 32 MSamples
Hence a memory size of 128 MB yields a maximum waveform length of 30 MSamples if
two markes are enabled. The maximum waveform length increases to 32 MSamples if
the internal hardware markers are used, and the complete memory is available for I/Q
data.
The minimum length of a waveform is 512 samples. If a waveform is shorter than this, it
is automatically repeated until it reaches the minimum length.
5.8.4.1 ARB User Interface
To access the ARB dialog, select "Baseband > ARB" or use the MENU key under "Base-
band".
The "ARB" dialog is divided into an upper and a lower general part together with a
"Marker" section.
The upper part of the menu is used for powering up, selecting and configuring ARB mod-
ulation.
The section "Multi Segment Waveform Options" is only indicated if a multi segment
waveform is loaded. In this part, the segment to be output is selected.
The buttons in the lower part of the menu open submenus for setting triggers and clocks,
for configuring the test signal and for calculating a multi segment waveform or a multi
carrier waveform.
Baseband Signal - Baseband Block
To Next Page
Loading...
