Rohde & Schwarz SMBV100A - Test Signals Settings

Remote Control Commands
R&S
®
SMBV100A
518Operating Manual 1407.6062.32 ─ 08
Example:
BB:ARB:TRIG:OUTP2:PULS:DIV 4
sets the divider for the marker signal on output MARKER 2 to the
value 4.
BB:ARB:TRIG:OUTP2:MODE PULS
enables the pulsed marker signal.
BB:ARB:TRIG:OUTP2:PULS:FREQ?
queries the pulse frequency of the marker signal.
Response: 33 000
the resulting pulse frequency is 33 kHz.
Usage: Query only
Test Signals Settings
[:SOURce<hw>]:BB:ARB:TSIGnal:CIQ:CREate................................................................518
[:SOURce<hw>]:BB:ARB:TSIGnal:RECTangle:CREate.....................................................518
[:SOURce<hw>]:BB:ARB:TSIGnal:SINE:CREate...............................................................518
[:SOURce<hw>]:BB:ARB:TSIGnal:CIQ:CREate:NAMed.....................................................518
[:SOURce<hw>]:BB:ARB:TSIGnal:RECTangle:CREate:NAMed..........................................518
[:SOURce<hw>]:BB:ARB:TSIGnal:SINE:CREate:NAMed...................................................518
[:SOURce<hw>]:BB:ARB:TSIGnal:CIQ:I...........................................................................519
[:SOURce<hw>]:BB:ARB:TSIGnal:CIQ:Q.........................................................................519
[:SOURce<hw>]:BB:ARB:TSIGnal:RECTangle:AMPLitude.................................................519
[:SOURce<hw>]:BB:ARB:TSIGnal:RECTangle:FREQuency...............................................519
[:SOURce<hw>]:BB:ARB:TSIGnal:RECTangle:OFFSet.....................................................519
[:SOURce<hw>]:BB:ARB:TSIGnal:RECTangle:SAMPles...................................................520
[:SOURce<hw>]:BB:ARB:TSIGnal:SINE:FREQuency........................................................520
[:SOURce<hw>]:BB:ARB:TSIGnal:SINE:PHASe...............................................................520
[:SOURce<hw>]:BB:ARB:TSIGnal:SINE:SAMPles.............................................................521
[:SOURce<hw>]:BB:ARB:TSIGnal:CIQ:CREate
[:SOURce<hw>]:BB:ARB:TSIGnal:RECTangle:CREate
[:SOURce<hw>]:BB:ARB:TSIGnal:SINE:CREate
Generates a signal and uses it as output straight away.
Example:
BB:ARB:TSIG:SINE:CRE
generates a test sine signal and uses it as output straight away.
Usage: Event
[:SOURce<hw>]:BB:ARB:TSIGnal:CIQ:CREate:NAMed <Filename>
[:SOURce<hw>]:BB:ARB:TSIGnal:RECTangle:CREate:NAMed <Filename>
[:SOURce<hw>]:BB:ARB:TSIGnal:SINE:CREate:NAMed <Filename>
Generates a signal and saves it to a waveform file.
Setting parameters:
<Filename> string
SOURce Subsystem