Instrument Function
R&S
®
SMBV100A
124Operating Manual 1407.6062.32 ─ 08
If activated, the display including backlight is completely switched off after the elapse of
the "Wait Time" when no entries via front panel, external mouse or external keyboard are
made.
This mode is recommended for preserving the display especially if the instrument is
exclusively operated via remote control.
SCPI command:
:DISPlay:PSAVe[:STATe] on page 463
Wait Time
Enters the idle time that must elapse before the display lamp is shut off when no entries
are made.
SCPI command:
:DISPlay:PSAVe:HOLDoff on page 463
Layout (Keyboard)
Selects the keyboard layout for the selected keyboard language.
The assignment of some keys depends on the selected layout and language.
SCPI command:
:KBOard:LAYout on page 472
:KBOard:LANGuage on page 472
5.2.3.14 Remote Channel Settings
The "Remote Channel Settings" dialog provides access to the settings for remote control.
The dialog is opened using the SETUP or MENU key under "Remote".
Besides the standard GPIB-setting, the selection of one of the possible emulations and
a user defined definition of the *IDN and *OPT string is possible.
General Instrument Settings
To Next Page
Loading...
