Rohde & Schwarz SMBV100A - Hardcopy Dialog

Instrument Function
R&S
®
SMBV100A
134Operating Manual 1407.6062.32 ─ 08
5.2.5.1 Hardcopy Dialog
Destination
Indicates that the hardcopy is stored in a file (see also "File Options" on page 135).
SCPI command:
:HCOPy:DEVice on page 466
Options
Opens the Hardcopy Options dialog for configuring the hardcopy parameters (see "File
Options" on page 135.
SCPI command:
n.a.
File
Some configuration parameters are already offered in the Hardcopy dialog. All configu-
ration parameters are available in "File Options" on page 135.
Automatic Naming
Activates, deactivates automatic generation of the file name. Automatic naming is con-
figured in the "Options…" submenu, see "File Options" on page 135.
SCPI command:
:HCOPy:FILE[:NAME]:AUTO:STATe on page 471
File Info
Indicates the file name. The file name can be entered either manually via the file manager
(button "File…") or generated automatically (Automatic naming checkbox). Automatic
naming is configured in the "Options…" submenu.
SCPI command:
:HCOPy:FILE[:NAME] on page 467
:HCOPy:FILE[:NAME]:AUTO:FILE on page 468
5.2.5.2 Hardcopy Options
This section describes the "Hardcopy Options" dialog.
General Instrument Settings