Rohde & Schwarz SMBV100A - Display Subsystem

Remote Control Commands
R&S
®
SMBV100A
461Operating Manual 1407.6062.32 ─ 08
Usage: Query only
:DIAGnostic:INFO:OTIMe?
The command queries the number of operation hours.
Return values:
<OTIMe> float
Example:
DIAG:INFO:OTIM
queries the operation hours.
Response: 100023
The instrument was operated for 100023 hours up to now.
Usage: Query only
:DIAGnostic:INFO:POCount?
The command queries the number of power-on events.
Return values:
<Pocount> float
Example:
DIAG:INFO:POC
queries the number of power on events.
Response: 123
The instrument was switched on for 123 times up to now.
Usage: Query only
7.7 DISPlay Subsystem
The DISPlay subsystem contains the commands to set the power-save mode of the
instrument.
:DISPlay:ANNotation:AMPLitude.....................................................................................461
:DISPlay:ANNotation:FREQuency....................................................................................462
:DISPlay:ANNotation[:ALL]..............................................................................................462
:DISPlay:DIALog:CLOSe................................................................................................462
:DISPlay:DIALog:ID........................................................................................................462
:DISPlay:DIALog:OPEN..................................................................................................463
:DISPlay:PSAVe:HOLDoff...............................................................................................463
:DISPlay:PSAVe[:STATe]................................................................................................463
:DISPlay:ANNotation:AMPLitude <State>
Fades out level display in the header of the instrument and displays asterisks instead.
Parameters:
<State> 0 | 1 | OFF | ON
*RST: 1
DISPlay Subsystem