Instrument Function
R&S
®
SMBV100A
203Operating Manual 1407.6062.32 ─ 08
For instruments with older version of the RF board, the LF output impedance is forced to
LOW and cannot be changed.
SCPI command:
[:SOURce]:LFOutput:SIMPedance on page 655
5.4.13.3 Pulse Generator
The "Pulse Generator" dialog is used to activate and configure a pulse modulation signal.
To open the "Pulse Generator" dialog, select "RF/A Mod" > "Configure" > "Pulse Gener-
ator" or use the MENU key under "RF/A Mod". Alternatively, you can configure the pulse
generator in the "Pulse Modulation" dialog of the "RF/A Mod" block.
Pulse Generator Settings
The dialog provides the settings for the pulse characteristics and trigger mode.
Video Sync Signal State - Pulse Generator
Switches on/off the output of the video/sync signal at the PULSE VIDEO connector. The
signal output and the pulse generator are automatically switched on with activation of
pulse modulation if pulse generator is selected as modulation source. The signal output
can be switched off subsequently.
SCPI command:
[:SOURce<hw>]:PGEN:STATe on page 669
Pulse Mode - Pulse Generator
Sets the mode of the pulse generator.
"Single"
A single pulse is generated in one pulse period.
"Double"
Two pulses are generated in one pulse period. Additional settings for
the double pulse are available in the menu.
SCPI command:
[:SOURce<hw>]:PULM:MODE on page 686
RF Signal and Analog Modulations - RF Block
To Next Page
Loading...
